Fluidity of methyl cellulose-contained suspensions and pastes prepared from differently milled Al2O3 powder

Abstract

The boundary factors of transition from a methyl cellulose (MC)-contained Al2O3 Suspension to a paste were investigated from the view points of adsorption affinity and correlation between average Surface to surface separation distance between particles (SDP) and polymer size. Non-damaged and damaged particle surfaces were prepared by wet-jet milling and ball milling, respectively. The amount of MC adsorbed on the wet-jet milled Al2O3 particle Surface was decreased by half compared to the ball-milled one. By increasing the solids loading from 10.0 to 12.8 vol%, the MC-contained Al2O3 suspension prepared from ball milling was turned into a paste. On the other hand, it prepared from wet-jet milling was not turned into a paste even if the solid loading was increased from 10.0 to 12.8 vol%. From the creep-recovery measurements, the fluidity of the wet-jet milled sample with 12.8 vol% of solids loading was estimated to be 4 times as large as that of ball-milled one. Therefore, it was found that the state of particle surface had a strong effect on the fluidity of a suspension. The polymer size estimated from the molecular weight and Flory exponent relationship was calculated to be 266 nm. The SDP of suspensions with 10.0 and 12.8 vol% solids loading was calculated to be 215 and 165 rim, respectively. With the decreasing of SDR the effect of adsorption affinity between the particle surface and the polymer became more striking because the contact area between them was increased. Hence, there are two factors that control the transition between a suspension and a paste; one is the relationship between SDP and polymer size, and the other is the adsorption affinity between the particle surface and the polymer. (C) 2008 Elsevier Inc. All rights reserved.